Difference between revisions of "Chapter Eight: Treatment of Waters With Special Contaminants"

From Ministry of Water DCOM Manual
(Created page with "= Chapter Eight: Treatment of Waters with Special Contaminants = In recent times, there has been an emergence of water contaminants which in the past, they were either of les...")
 
Line 71: Line 71:
  
 
A Korean company has produced CDI which remove fluoride and dissolved salinity in water without chemicals or clogging membranes. This technology is called MCDI and it removes ionized materials in water by using state of the art electrodes running with very small amount of electricity of just 1.5 volts. (Figure 8.1) Its operational cost is lower than any other defluoridation and desalination technologies.
 
A Korean company has produced CDI which remove fluoride and dissolved salinity in water without chemicals or clogging membranes. This technology is called MCDI and it removes ionized materials in water by using state of the art electrodes running with very small amount of electricity of just 1.5 volts. (Figure 8.1) Its operational cost is lower than any other defluoridation and desalination technologies.
 +
 +
<gallery>
 +
/home/witness/Pictures/MAJI/Link to pic8.jpg|Figure 8.1: Configuration of Capacitive Deionization
 +
</gallery>

Revision as of 21:33, 30 April 2020

1 Chapter Eight: Treatment of Waters with Special Contaminants

In recent times, there has been an emergence of water contaminants which in the past, they were either of less concern or their health impacts not known. These special contaminants are bringing new dimension in the manners in which they are supposed to be dealt with. This chapter presents special water contaminants that have emerged to be of major health concern. Treatment techniques and methods for these special contaminants have been also be provided.

1.1 1.1 Natural Organic Matter

Over the past 10–20 years, the amount of the natural organic matter (NOM) has increased in raw water supplies on several areas. The presence of NOM causes many problems in drinking water treatment processes, including: (i) negative effect on water quality by colour, taste and odour problems, (ii) increased coagulant and disinfectant dose requirements (which in turn results into increased sludge and potential harmful disinfection by-product formation), (iii) promoted biological growth in distribution system, and (iv) increased levels of complexed heavy metals and adsorbed organic pollutants.

In Tanzania, this problem is more pronounced at Igombe dam, a source of water supply for Tabora Municipality. A study on water quality monitoring at Igombe Dam conducted between October 2009 – November 2010, revealed that color and turbidity of the raw water is very high due its very high humic content and algae substances. These substances are mainly due to the organic matter from the surrounding dry forest. With respect to the conclusions of the first report (February 2, 2010), it is known now that the current treatment is not sufficient to guarantee a good water quality in the network, mainly due to a risk of bacterial re-growth and also due to an acidic pH, causing pipe corrosion. Igombe Dam water is characterized by high concentrations of organic matter. The organic matter is thus of natural origin, in other words natural organic matter (NOM). The collected water quality data confirm the high amount of natural organic matter (NOM) present in the raw water of the Igombe Dam. The high concentration of NOM present in this water may cause different problems, including excessive chlorine demand, formation of disinfection by-products (DBPs), taste and odor problems and bacterial re-growth in the distribution system. The low concentrations of the different nitrogen compounds (nitrate, ammonia) in the raw water of the Igombe Dam indicate moderate to little agricultural and human activities in the watershed, confirming that the source of the organic matter present in the raw water is principally of natural origin. Therefore, one of the principal objectives of the future water treatment plant at Igombe will be the reduction of NOM (measured as DOC and UV254) through the different treatment processes - principally coagulation/sedimentation and (biological) filtration.

1.2 1.2 Arsenic

Occurrence of arsenic in groundwater is increasingly becoming a serious pollution problem to human health worldwide. The occurrence of such pollutants can either be geogenic or anthropogenic. Recently, elevated concentrations of arsenic (>10 µg/L) has been reported in the northern part of Tanzania and are associated with gold mining activities within Lake Victoria Basin (LVB). The geology of LVB is dominated by greenstone belts in the North-Western region up to Mpanda and Lupa Mineral fields in the Ubendian system of the western parts of Tanzania. These regions are characterized by small, medium and large scale mining, using various technologies. A number of adverse human health effects are noticed among the communities living around the mining areas. Based on developed geo-statistical model using past study results on total arsenic in 9 districts, a spatial trend (R² =0.19) in the east-west transect was noticed. In addition, a spatial trend (R² =0.009) was observed along the north-south transect. The reported study results are very potential to improve drinking water suppliers in targeting safer groundwater sources.

Thus, water treatment must consider this pollutant for its removal. One way of completely removing this pollutant is to think of a number of different units and modules such as to include oxidation, coagulation-flocculation, and membrane techniques

1.3 1.3 Radioactive

Radioactive, also called radiological contamination, is the deposition of, or presence of radioactive substances on surfaces or within solids, liquids or gases, where their presence is unintended or undesirable. Such contamination presents a health hazard because of the radioactive decay of the contaminants, which produces such harmful effects as ionizing radiation (namely α, β, and γ rays) and free neutrons. The sources of radioactive pollution can be classified into two groups: natural and man-made. In Tanzania such radiactive materials have been reported in areas of Nchemba and Bahi.

Thus, it is recommended that water sources with radom should not be exploited by any water authority of project.

1.4 1.4 Fluoride removal from drinking water

In Tanzania, fluorides are distributed in the regions of Arusha, Moshi, Singida, and Shinyanga, with a severely affected area being on the foothills of Mount Meru and Kilimanjaro. Defluoridation is necessary when the fluoride concentration is higher than acceptable limits as per Tanzania Standards. Excessive fluorides in drinking water may cause mottling of teeth or dental fluorosis, a condition resulting in the coloration of the tooth enamel, with chipping of the teeth in severe cases, particularly in children. With even higher levels of fluorides, there are cases of fluorosis of the bony structure. The chief sources of fluorides in nature are fluorapatite (phosphate rock), fluorspar, crylite and igneous rocks containing fluosilicates.

A designer in deciding on whether or not to include defluoridation in a water supply scheme should therefore consider both number of potential consumers, alternative sources, the financial consequences both in capital and running of defluoridation plant and whether or not there is a possibility to dilute the water containing the fluoride as a means of reducing the concentration.

1.5 1.5 Toxic Cyanobacteria in Drinking Water

Concern about the effects of cyanobacteria on human health has grown in many countries in recent years for a variety of reasons. These include cases of poisoning attributed to toxic cyanobacteria and awareness of contamination of water sources (especially lakes) resulting in increased cyanobacterial growth. Cyanobacteria also continue to attract attention in part because of well-publicised incidents of animal poisoning. Problems associated with cyanobacteria are likely to increase in areas experiencing population growth with a lack of concomitant sewage treatment and in regions with agricultural practices causing nutrient losses to water bodies through over-fertilization and erosion. This problem shall also increase in areas depending on dams for water provision especially those dams shared with livestock.

Outbreaks of human poisoning attributed to toxic cyanobacteria have been reported in Australia, following exposure of individuals to contaminated drinking water, and in the UK, where army recruits were exposed while swimming and canoeing. However, the only known human fatalities associated with cyanobacteria and their toxins occurred in Caruaru, Brazil, where exposure through renal dialysis led to the death of over 50 patients. Fortunately, such severe acute effects on human health appear to be rare, but little is known of the scale and nature of either long-term effects (such as tumour promotion and liver damage) or milder short-term effects, such as contact irritation. Eutrophication is the main contributor of occurrence of cyanobacteria.

In Tanzania, eutrophication is observed and reported to be one of the most water quality pollution challenges facing Lake Victoria today. Despite numerous and intensive research efforts to alleviate the problem, the present extent and magnitude of the problem is unprecedented (Myanza et al., 2014). There has been also reported presence of high phycocyanin (PC) pigment values (19.9 to 495 μg/l) unique to cyanobacteria, well above the WHO alert level of 30 μg/l in earthen dams in Arusha �(Eliakimu, Machunda et al. 2018)�. The PC is associated with a variety of toxins affecting humans and animals. These dams are shared between animals (wild and domesticated) and human).

Human influences such as population growth, urbanization and agriculture contribute to the cause of algal blooms which disrupt natural foodwebs. Furthermore, some algae are toxic e.g. blue-green algae, also known as cyanobacteria. Algae are responsible for odours and tastes, as well as toxins, though attempts to use odour and taste as potential surrogates for the presence of toxins are inconclusive. Because of concern about the potential detrimental water quality impacts on human and animal health, eutrophication necessitates active water source control and monitoring of water quality. Eutrophic water increases the costs of water treatment and water supply to consumers. Climate change amplifies eutrophication as rising temperatures favour cyanobacteria over other phytoplankton species (e.g. diatoms). Warming of surface waters also enhances vertical stratification of lakes, again favouring cyanobacteria.

Eutrophication is the enhancement of the natural process of biological production in rivers, lakes and reservoirs, caused by increases in levels of nutrients, usually phosphorus and nitrogen compounds. Eutrophication can result in visible cyanobacterial or algal blooms, surface scums, floating plant mats and benthic macrophyte aggregations. The decay of this organic matter may lead to the depletion of dissolved oxygen in the water, which in turn can cause secondary problems such as fish mortality from lack of oxygen and liberation of toxic substances or phosphates that were previously bound to oxidized sediments. Phosphates released from sediments accelerate eutrophication, thus closing a positive feedback cycle. Some lakes are naturally eutrophic but in many others the excess nutrient input is of anthropogenic origin, resulting from municipal wastewater discharges or run-off from fertilizers and manure spread on agricultural areas. Losses of nutrients due to erosion and run-off from soils may be low in relation to agricultural input and yet high in relation to the eutrophication they cause, because concentrations of phosphorus of less than 0.1 mgl-1 are sufficient to induce a cyanobacterial bloom.

Design considerations and procedures for cyanobacterial removal Thus, it is important to consider removal of cyanobacteria when designing water treatment plant. The design consideration for cyanobacterial removal should be centred more in lakes and reservoirs. The areas of concern should be those which will be using Lake Victoria, various types of dams where water is likely to be polluted by organic matter and nutrients and reservoirs as their source of water supply. A combination of water treatment units and modules as presented in preceding section is recommended for the effective and efficiency toxic cyanobacterial removal.

For dams provision should be included in the design to limit intrusion of animals into the water for domestic purposes by providing cattle troughs where animals can access drinking water without polluting the resource.

1.6 1.6 Available methods for removal of special water contaminants

The following methods may be considered for attaining water which is free from designated contaminants.

  • Desalination
  • Additive methods
  • Adsorption methods
  • Reverse Osmosis
  • Membrane filtration
  • Capacitive De-Ionization (CDI)

1.7 1.7 Desalination

Desalination effectively removes all dissolved impurities from water. This can be accomplished in one of several ways, by freezing, by distillation, by electrolysis, Capacitive Deionization(CDI) or by reverse osmosis (RO). There are some research efforts to use biomass2 based materials for defluoridation. The cost of desalination is high although the costs of reverse osmosis have fallen considerably in recent years. Nevertheless, this method is more appropriate to deal with brackish or sea water although it should not be entirely ruled out where there a few if any alternative sources and there is a good supply of electricity.

1.7.1 1.7.1 Additive method

In this method, one or more chemicals are added to water. The fluoride is then absorbed and both the additive and the fluoride are consequently removed by using conventional treatment processes such as sedimentation and filtration. A wide variety of materials have been tried including lime, magnesium sulphate, magnesium oxide, calcium phosphate, aluminium sulphate, various natural earths, bauxite, sodium silicate and sodium aluminate.

Excessive lime treatment for softening affects removal of fluoride due to its absorption by the magnesium hydroxide floc. However, sizeable fluoride removal is possible only when magnesium is present in large quantities which may not always be the case and magnesium may have to be supplemented in the form of salts.

The initial cost and cost of chemicals is very high and resultant sludge is environmentally difficult to dispose of.

1.7.2 1.7.2 Adsorption methods

Adsorption methods employ a bed or filter of generally insoluble material through which the water is allowed to percolate periodically. As it becomes saturated, with the fluoride 'removed, the absorptive media is either replaced or appropriately regenerated.

Materials used have included charred bone, activated alumina, activated carbon, tricalcium phosphate, natural and synthetic ion exchange materials and aluminium sulphate. Studies elsewhere have revealed that activated carbon has a good capacity to remove fluoride where the concentration is less than 10 mg/l. and the water is low in salinity. An activated carbon for fluoride removal has been developed in India by carbonising paddy husk or saw dust, digesting under pressure with alkali and quenching it in a 2% alum solution. The spent material can be regenerated by soaking it in a 2% alum solution. Also a granular ion exchange material, 'Defluoron 2', which is sulphonated coal operating on the aluminium cycle has been developed in India.

The bone char method developed and promoted by the Ngurdoto Defluoridation Research Station (NDRS) of the MOW has been widely applied for domestic and institutional point of use defluoridation. In recent times Reverse Osmosis (RO) has been applied for desalination at Gairo small town, in Morogoro and in Arusha for defluoridation.

1.7.3 1.7.3 Capacitive deionization (CDI)

Capacitive deionization (CDI) is a technology to de-ionize water by applying an electrical potential difference over two electrodes, which are often made of porous carbon. Anions, ions with a negative charge, are removed from the water and are stored in the positively polarized electrode. Likewise, cations (positive charge) are stored in the cathode, which is the negatively polarized electrode. Today, CDI is mainly used to remove ion materials such as Fluoride, Nitrate, Lime, and salinity water. Other technologies for the deionization of water are distillation, reverse osmosis and electrodialysis. Compared to reverse osmosis and distillation, CDI is considered to be an energy-efficient technology for remove ion materials.

A Korean company has produced CDI which remove fluoride and dissolved salinity in water without chemicals or clogging membranes. This technology is called MCDI and it removes ionized materials in water by using state of the art electrodes running with very small amount of electricity of just 1.5 volts. (Figure 8.1) Its operational cost is lower than any other defluoridation and desalination technologies.